Smoke grenade launchers 1:35 for the Pz.Kpfw.II Ausf. b are a small resin add-on set from IBG models, not a kit of the tank. The set is cut for the IBG Models Pz.Kpfw.II Ausf. b kit.
Responsibility details are not available.
This item is not a kit of the tank but a small resin accessory in 1:35 scale. It replaces the simple plastic parts of the smoke grenade launchers with a casting that has crisper edges and a more cleanly rendered surface. The set is cut for the IBG Models Pz.Kpfw.II Ausf. b kit, so it seats on the shapes of that particular hull without major modification — on another kit expect to adjust the glued surface by hand.
Smoke grenade launchers were a common part of the rear end on German armored vehicles of the period, and on a finished model they are a detail that is clearly visible in the silhouette of the vehicle. On parts this small, injection-molded plastic is limited by the parting line of the mold, while a resin casting can handle them more finely.
First wash the parts in lukewarm water with a drop of detergent, so that the mold release residue disappears from the surface — otherwise paint will not hold on them. Cut the casting blocks off with a thin saw or a sharp knife, not with nippers, so that the casting does not break. Sand only wet and with respiratory protection. It is glued with cyanoacrylate glue (super glue), as ordinary cement for plastic does not work here. Apply a thin layer of primer before painting, and both acrylics and enamels will then sit on it well.
The accessory is supplied unassembled and unpainted. The base kit, glue and paints are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!