An upgrade photo-etched and 3D-printed set for the StuG III Ausf. G in 1:35 scale from Rye Field Model adds fine metal and printed details to a model that injection-molded plastic cannot capture.
Responsibility details are not available.
This is an accessory set, not the model itself. It contains photo-etched metal parts completed with 3D-printed components with which you replace or refine selected parts of a plastic kit of the German StuG III Ausf. G assault gun. The aim is to raise the fidelity of the model in places where the injection-molded plastic is simplified from the factory.
The Sturmgeschütz III Ausf. G was the most widespread version of the German assault gun built on the chassis of the Panzer III tank. It carried a long-barreled 7.5 cm StuK 40 gun and from 1942 served both to support the infantry and as a tank destroyer. It was the most numerously built German tracked fighting vehicle of the Second World War.
Separate the photo-etched parts from the fret carefully with a sharp knife on a hard surface, and make precise bends with a bender or along a ruler. Use cyanoacrylate glue for gluing; small flat parts can also be fixed with varnish. Wash and clean up the 3D-printed components before gluing. Bear in mind that the set is made for more advanced builders.
This is an accessory set, not a complete model. The base kit, glue and paints are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
