1:35 early type wheel set for the G7107 truck from DEF Model replaces the plastic wheels from the box with resin castings with a weighted deformation of the tire. It is not a model of the vehicle but an accessory for it.
Responsibility details are not available.
Resin replacement wheels from the manufacturer DEF Model for the American truck G7107 of the G506 line, in the form designated as the early type. The set replaces the wheels supplied in the plastic kit. On a truck the wheel is the part that stands on the ground and is visible from every angle, and at the same time the part on which injection-molded plastic fails most: the parting line runs across the whole tread, the fine pattern of the tread is rounded off in the mold and the tire looks hard and over-inflated.
A casting holds the sharp pattern of the tread and even the small lettering on the sidewall, and above all it allows the weighted deformation of the tire to be rendered: at the point of contact with the ground the tire is slightly flattened and the sidewall bulged, as if the weight of the vehicle were standing on the wheel. It is exactly that which makes the difference between a model that looks built and a model that looks parked. The manufacturer also makes a variant with general type wheels.
The G7107 is an American truck with drive to all wheels from the line of vehicles listed under the designation G506. It was produced in large numbers during the Second World War and besides the American army it served with the Allies, reaching them under Lend-Lease. It was a typical second-line workhorse and a rewarding modeling subject precisely because it was everywhere.
First wash the resin parts in lukewarm soapy water, so that the mold release from the mold comes off the surface, because without that neither paint nor primer will hold. Cut the casting blocks off with a fine saw; on wheels the block is usually at the point where the tire contacts the ground, so after cutting, level the surface with abrasive paper used wet and with protection for your airways, and take the chance to level the wheel flat at the same time. Glue with cyanoacrylate glue. Apply a thin coat of primer before painting. Keep the tire dark gray rather than black, shade the disc separately and go over the edges of the tread with a dry brush; apply the final mud and dust with pigments from the bottom upward and match them to the base of the diorama.
This is an accessory set, not a complete model. The base kit, glue and paints are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!