The set of replacement heads Puppetswar -Ninja Reaper Heads 28/32mm serves for modifying wargaming figures of 28 to 32 mm size.
Responsibility details are not available.
This is not a standalone figure or a kit but an accessory for conversions. The set from the Puppetswar line offers heads in the treatment of hooded figures with the face covered, with which the original heads on gaming figures can be replaced. Swapping a head is one of the quickest ways of giving a unit a face of its own and setting it apart from the identical models of other players.
The figure 28 and 32 mm does not denote a ratio of reduction as it does with models of vehicles but the usual height of a figure in gaming systems; it is therefore a guide to which miniatures the heads match in size. The motif of a hooded figure comes into play with themes of warriors in the shadows, with cult units and with disguises, where the face is meant to be hidden.
Cut off the original head with a sharp knife as close to the neck as possible and level the surface with a file, so that the new part sits without a gap. It is a good idea to strengthen the joint with a short wire pin, for which a fine drill is enough; the head then holds even during ordinary handling on the gaming table. Fill any gap with modeling putty and sand it down once it is dry, otherwise it will stay visible after the finish.
Against an uncovered face a hooded head has one practical advantage: it does away with painting the eyes, that is the place where the result on gaming figures goes wrong most often.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!