The decal sheet Focke-Wulf Fw 190 F-8 in 1:48 scale from the Hungarian manufacturer HAD models offers markings for two Luftwaffe machines.
Responsibility details are not available.
A waterslide decal sheet from the Hungarian manufacturer HAD models for models of the Focke-Wulf Fw 190 F-8 ground attack version in 1:48 scale. The F-8 version was the attack derivative of the Fw 190 fighter, adapted to work over the battlefield and to carry bomb loads. The sheet is an accessory for a model that is already built and painted, not a kit.
The sheet offers two marking variants of Luftwaffe machines, that is two complete sets of national insignia, individual codes and supplementary lettering. A smaller number of variants means more room on the sheet, so the individual designs tend to be rendered in greater detail. The printing is done on a thin carrier film in accurate register; the sheet of schemes enclosed in the package shows where the designs go.
Varnish the area under the decal with gloss clear coat, otherwise a milky edge will appear around the carrier film. Cut the design out close around the printing, dip it in lukewarm water for a few seconds and let it rest until the film releases from the backing. Slide it onto the dampened place, fine-tune the position with a soft brush and soak the surplus water up with absorbent paper. Lay a softener onto the engraved lines and panel joints, so that the decal follows the surface. Once it has dried perfectly, unify the model with a matte or semi-matte varnish.
This is a decal sheet, not a kit. The model, paints, glue and varnishes are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
