Color elements of the pilot compartment of the F-104G made by 3D printing, cut for the Italeri kit, in the smaller variant of the set.
Responsibility details are not available.
The F-104G Starfighter is the fighter-bomber form of the Starfighter and the most widespread version of the whole line. You will recognize it by its long slender fuselage, its short thin wings and its high-set horizontal tail surface. The cockpit is narrow and clearly built up, so with the canopy slid back practically the whole instrument panel and the side consoles are visible from it.
Color elements of the pilot compartment made by 3D printing, as the name of the set states, cut for the Italeri kit. The elements come already in color, so coloring in the small instruments, placards and harness falls away. The plastic relief has real depth, so the panel does not look like a drawing on a flat surface. The attribute small version distinguishes the smaller variant within the same line; the exact extent is given by the instructions of the manufacturer.
The sheet is soaked briefly in lukewarm water, the element is slid off the carrier paper and seated on gloss varnish, which holds it; it has no adhesive layer of its own. A matte base is a mistake, and do not use a decal softener, as it will damage the printed resin. First clean and degrease the base, separate the element with the tip of a sharp blade and transfer it with tweezers. On curved surfaces press it down in small sections, so that the element does not ripple, and do not needlessly varnish over the finished work.
The kit of the aircraft, paints, glue and tools are not part of the delivery, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
