A cast version of the tailless Horten H IV glider of 1941 in 1:48 scale. A flying wing with a span of twenty meters and the pilot lying prone. The slender wing calls for careful support when sanding.
Responsibility details are not available.
Reimar and Walter Horten devoted the 1930s and 1940s to flying wings. Their H IV of 1941 was a tailless glider with a span of twenty meters and an unusually slender wing whose aspect ratio exceeded twenty. A figure like that appeared at the time only on the highest-performing sailplanes and was meant to deliver a glide ratio that a conventional design with a fuselage and a tail would not venture.
The pilot lay prone in a glazed nose in the middle of the leading edge. The position cut frontal drag to a minimum, but it was exhausting after a longer flight and the view to the rear all but disappeared. The machine has no rudder at all; turning was handled by brake and flap surfaces near the wingtips, operated asymmetrically. Only a few finished examples were built and one has survived in an American collection, where it serves as evidence of how far the tailless layout got in its day.
The work of the Horten brothers did not end with gliders. A few years later the same workshop produced the jet-powered tailless H IX, in which the flying wing met turbines for the first time, and after the war Reimar Horten went on designing in Argentina. The H IV stands in the middle of that family and shows how far it was possible to get without an engine, purely with a carefully twisted wing.
Casting resin takes very fine detail, but it behaves differently from injection-molded plastic. The parts come out of the mold with a thin flash along the edges, which you remove by wet sanding with fine paper. The most sensitive part of this subject is the long, thin wing, so support it over its whole area while working on it and do not press on the tips. Gaps in the joints are filled with a thicker cyanoacrylate glue mixed with sanding dust; plastic putty adheres poorly to this surface.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!