Small nuts with a screw stem and a washer, 0.7 mm in size, intended for detailing models in 1:72 to 1:48 scale.
Responsibility details are not available.
The set holds miniature nuts with a washer and with a shank, that is with a pin by which the part is seated in a pre-drilled hole. The name gives a size of 0.7 mm and use in 1:72 to 1:48 scale. Fasteners are exactly the kind of detail that a kit only suggests: the hexagon is filled in, the edges are blurred and after painting hardly a trace of it is left. Replacement nuts have a sharp shape and a hexagon that reads clearly even once painted.
On armor plates and their joints, on engine covers, on hinges, on chassis and frames, and anywhere a real bolted joint ought to be visible. Another proven place is a surface where the difference between a coarsely shaped part and the fine detail around it needs evening out.
Drill the hole with a micro drill of a diameter matching the shank, and preferably try the strength of the material on a scrap piece first. Pick the parts up with tweezers with fine jaws and work over a surface with raised edges, because a nut of this size, once dropped, will never be found again. A minute drop of cyanoacrylate glue applied with the tip of a toothpick is enough to hold it, not a drop from the bottle. Degrease the surface before painting and use a primer, so that the tiny part does not disappear into a thick coat of paint. The hexagon stands out when a darker tone is added around it.
The fasteners are supplied according to the name. The model, drills, glue and paints are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
