A nut with a shank seven tenths of a millimeter wide, with no washer under the head. A rewarding dimension for 1:35, where it corresponds to an ordinary bolt from a chassis, and at the same time a good start for a modeler trying such a detail for the first time.
Responsibility details are not available.
Before the glue has its say, hold one piece at the place it is to belong and look at it from the side and from above. Compare it with a neighboring molded detail, best with a rivet or a head the kit already has: if the new part is markedly heftier, the whole surface will split into two different scales. The dry trial takes a minute and saves an hour of repairs.
Seven tenths of a millimeter gives in 1:35 a joint just under twenty-five millimeters across. That is an ordinary bolt from a fender mounting, from a headlight bracket or from the foot of a handle. In 1:24 it is seventeen millimeters, that is a dimension you know from the wheel of a passenger car, and in 1:16 eleven millimeters, which corresponds rather to the smaller joints on an engine.
It can also be verified whether the surface will take another part at all. On a very articulated surface it happens that a new head overlaps the edge of a panel or sinks into a recess. When that occurs, another dimension usually does not help, but another position a little further on does, where the surface is flat and the joint can be lined up by eye into a continuous row.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!