A pair of the common wing tanks together with the pylons for a model of the F-16 in 1:48 scale, cast in resin.
Responsibility details are not available.
A tank of three hundred seventy gallons capacity, that is roughly fourteen hundred liters, is a common part of the equipment of this fighter aircraft. In service photographs a pair of these tanks appears more often than any other equipment, and a machine without them looks more like a ceremonially polished exhibit than an aircraft in daily service.
According to the name the set also holds the pylons, which simplifies the build only in appearance. A cast pylon has its upper mating surface flat, whereas the underside of the wing is rounded. The surface therefore has to be adapted: lay sandpaper of around six hundred grit on the underside of the wing, run the pylon over it and keep checking when it seats with no gap.
Measure the position of both pylons from the root of the wing, not from its tip, because it is precisely at the root that the panel lines tend to be distinct and symmetrical. The surest way is to cut out a paper template and use it on both halves. A difference of a few millimeters in the spacing is clearly apparent on a finished model when seen from the front. Before gluing proper it also pays to assemble both parts dry and to note which way the longer part of the tank faces, because swapping the sides is more common with castings of similar shape than anyone would expect.
After it has dried, look along the fuselage from behind: both tanks should have the same height and the same inclination, and no light gap may be left between the pylon and the skin. First rid the castings of mold release agent, otherwise the glued joint will age sooner than the model.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!