Resin wheels with weighted tires for a model of the Hawker Sea Hawk in 1:72 scale from the Ukrainian maker Armory. An accessory for a model, not an aircraft kit.
Responsibility details are not available.
A set of cast wheels with weighted tires for a model of the British carrier aircraft Hawker Sea Hawk in 1:72 scale. It is not an aircraft kit but an accessory that replaces the plastic wheels from the kit. The underside of the tire is cast flattened, as if the weight of the machine were pressing on the wheel, and the one-piece casting does without a parting line running through the middle of the tire. It is a universal set.
The Sea Hawk was a British single-seat carrier jet with a straight wing. It first flew as early as the 1940s and entered service with the naval air arm in 1953. Its distinguishing feature is the bifurcated jet pipe, which takes the gases out on both sides of the rear fuselage and thus left room in the fuselage for fuel. It was powered by the Rolls-Royce Nene engine. It saw action over Suez in 1956 and served with the navies of India, the Netherlands and Germany as well. Later versions were built by Armstrong Whitworth.
Wash the parts in warm soapy water so that the mold release agent disappears. Cut the casting block off with a fine-toothed saw and sand the face down, protecting your breathing while you sand. Glue with cyanoacrylate, that is, super glue; cement for polystyrene does not hold on resin. Point the flattened part of the tire toward the base and align both sides. Spray a primer before painting.
The set is supplied unpainted. Glue, paints and the base kit are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
