Eduard 1:72 P-51B/C exhaust stacks without the shroud, 3D printed are 3D printed replacement exhausts without a shroud for a Mustang model in 1:72 scale. The version with the exhaust shroud is a separate item.
Responsibility details are not available.
A small replacement set from the Czech manufacturer Eduard for a model of the P-51B or P-51C fighter in 1:72 scale. The parts are made by 3D printing in resin, so they are not photo-etch and certainly not an aircraft kit. This version holds the exhaust stacks alone, without the metal shroud; anyone building a machine that had the shroud should reach for a separate item that has the shroud in its name.
The exhaust stacks of the Mustang project on both sides of the engine section and, seen from the side, make up one of the first details the eye notices. Injection-molded plastic handles them only roughly: the mouths stay blanked off and the walls are several times too thick for the scale. The printed parts have open mouths and crisp outlines, so they come close to the real shape. The swap takes a few minutes and calls for no intervention in the structure of the model.
The most delicate part is separating them from the print supports: use a sharp blade or a fine saw and lead the cut as close to the part as you can, but not into it. Sand wet, as resin dust must not be breathed in. Wash the part in lukewarm soapy water before painting so that no print residue is left on the surface. It is bonded with super glue, laid down in a micro dose with a pin. For painting, a dark metal shade with rust and soot tones works; suggest the streak running back along the fuselage thinly, so that the mark does not look like a smear.
An accessory for a plastic model, not a kit. The model, glue and paints are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
