A round styrene rod 2.0 mm in diameter. Stiff enough for axles, exhausts and load-bearing features, while it can still be cut with a knife and sanded.
Responsibility details are not available.
As the diameter grows, the role of the profile changes too. While thin rods serve to suggest a detail, this one already carries something. Two millimeters is enough for an axle onto which wheels are fitted, for the pivot of a rotating turret or for a strut that will take the weight of a superstructure. At the same time the material is still soft enough to be divided with an ordinary knife and shaped with abrasive paper.
Modelers make exhaust pipes, posts and masts, engine room piping, winch shafts, the shanks of towing hooks and the supporting columns of shelters on dioramas from it. In the scale of ground vehicles it matches heavier piping or a rod, and on ships it serves as a mast section or the funnel of a smaller vessel.
A proven trick is to clamp the rod in the chuck of a hand drill and hold abrasive paper or a file against the turning material. That gives a precisely turned cone, radius or shoulder without needing a lathe. The same way you can create the flare of an exhaust or the tapered tip of a mast.
On gluing and the surface: the material is polystyrene, so ordinary liquid cement for plastic models holds it and with a larger contact area a very strong joint results. Before painting it is enough to degrease the surface and spray it with a primer; no further treatment is needed. The higher stiffness compared with thin profiles means that a longer run stays straight even without support. There is a flip side to that as well: at this diameter it can no longer be bent into curved shapes without heating.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!