A black polystyrene sheet 0.25 mm in a format of roughly 15 x 30 cm, colored through its whole thickness, for cutting and bending.
Responsibility details are not available.
A black polystyrene sheet 0.25 millimeters thick and roughly 15 by 30 centimeters in format. The material is colored through, so a cut edge stays black and does not shine as a white line the way it does on the usual white sheets. That is exactly why it suits anywhere a part stays visible without paint: on floors, bulkheads, window infills, blanking plates behind radiator grilles or for closing off unwanted openings.
A quarter of a millimeter does not have to be cut all the way through. It is enough to run a sharp knife along a straightedge a few times and snap the sheet in the score; the edge then comes out straight. Without heating the material bends into a gentle curve, and after warming over a radiator it holds a sharper shape as well. It glues with a thin cement for polystyrene, which draws itself into the joint.
On models with glazing the sheet is used to cut inner frames, and in dioramas it serves as a base under paving or as a thin leveling shim under uneven terrain. The manufacturer states resistance to ultraviolet radiation, so the sheet does not grow brittle in the light as fast as ordinary polystyrene. The goods are sold as single sheets.
The drawback is poorer visibility of marked lines when cutting, so it pays to mark it out with a light pencil or a sharp point on the glossy side.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!