A styrene tube with an outer diameter of 7.9 mm and a length of 35 cm, white, ready for cutting and drilling.
Responsibility details are not available.
A round tube of white polystyrene with an outer diameter of 7.9 millimeters, which corresponds to five sixteenths of an inch in the maker's original sizing system. The length is 35 centimeters and the goods are sold by the piece. The wall is thick enough to take drilling as well as cutting an opening for a lid.
In 1:35 scale it becomes drums, water cans, the chimneys of field stoves or the casings of silencers. In larger scales it serves as the body of a rocket, the tank of a compressor or a lighting mast. The hollow section allows wire to be threaded through the inside and the part made into the load-bearing element of a whole structure, which diorama builders will appreciate.
The cleanest cut is made by turning the tube against the blade and increasing the pressure gradually rather than all at once. The squareness of the edge is then trued up on sandpaper laid on a tabletop. The material is joined with liquid cement for polystyrene and once dry it is sanded and filled just like kit parts, so the joint can be hidden completely.
Sand the surface with the finest paper before painting: tubes carry fine longitudinal lines from production that are clearly visible once a gloss paint has been sprayed on.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!