A diameter of 0.7 mm, a flat head of wide shape with a simple slot, intended for detailing motorcycle models.
Responsibility details are not available.
This step tends to be the first choice when a modeler is replacing the molded dots on chain guards, on footpegs and on the mounting of fenders. A shape of head with a large area and a low height comes across as soft from close by rather than sharp, and that is exactly why it suits even places where a sharp hexagon would look too technical.
A dry assembly on friction has the advantage that it can be undone at any time. But as soon as the model is handled, a small head works loose and disappears. Anyone counting on the machine being carried about or taken to a show should secure it with glue.
The safest is a gel glue applied with a pin into the hole before the element goes in. The thin variant likes to creep up the shank and leaves a glossy ring around the head, which on matte paint there is nothing to mask with. Anyone gluing at the very end should put a piece of paper tape under the place as a catching rim.
Think over, too, whether you will be able to reach the place at all once the surrounding parts are glued. Access with a tool matters more on a small joint than on anything else; afterward it can only be fitted with tweezers bent to a right angle.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
