A diameter of 0.7 mm in the flange version. At this grade the widened collar under the head is already clearly visible and spreads the load around the hole.
Responsibility details are not available.
The seventh tenth is the last grade that still belongs to the group of finest diameters. This tends to be the boundary beyond which you can make out the shape of the head without a magnifier. On a motorcycle this dimension corresponds to the mounting of radiators, sheet-metal chain covers or cable brackets.
Drill square. A slanted hole pulls the head to one side and the collar then seats on only half its circumference, which is immediately visible from the side. Support a thin wall from the inside with a piece of plastic or with putty, otherwise a bulge forms around the bore. Mark the spot beforehand with the point of a needle so the bit does not run off the glossy surface.
Before you reach for the glue, try the part dry and look at the joint from the side and from above. The position can only be corrected until the cyanoacrylate glue has set; after that nothing is left but to break it out and drill a new hole beside it, which shows on a visible surface for good.
What is supplied are the parts themselves, intended for finishing a model. The kit, glue and bits are not included.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
