Brass tubes 2.8 mm (2 pieces) from AK interactive are the thickest hollow brass sections in the line, for scratchbuilding and for detailing models.
Responsibility details are not available.
A package of two hollow brass tubes with an outside diameter of 2.8 mm, which is the largest diameter in this line. It is modeling material for scratchbuilding, not a kit. Brass can be cut, bent and soldered, and the hollow tubes will serve as substantial exhausts, piping and the barrels of large guns.
Cut with a fine razor saw or a snap-off blade knife while rotating the tube and clean the ends up; on a barrel drill the muzzle out slightly. The smaller diameters in the line can be telescoped into this tube to create stepped stubs. Glue with super glue (cyanoacrylate) or solder, and before painting degrease the brass and apply a metal primer.
This is raw material, not a finished part. Clean up the sharp ends after cutting. Glue, paints and tools are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
![1:72 PZL 37 Łoś [FLY]](https://cdn.cloud404.cz/clients/cdn147/gallery/products/89074/gall_g-326-1-72-pzl-37-o-fly-big.jpg)
