A modeling saw with a handle and three interchangeable blades for fine cuts on a kit. A tool for precise work on small parts.
Responsibility details are not available.
The modeling saw set contains, according to the name, three blades and is intended for fine cuts for which an ordinary saw is too coarse. A thin blade removes little material, so the cut stays narrow and a part keeps its dimension. It will find a use in dividing parts, in shortening profiles and tubes, and also where an already glued assembly has to be cut through and modified.
A handle and three blades are included, as the designation of the set states. The blades are clamped into the holder and can be changed as needed, so the tool lasts longer than a one-piece saw. The details of the clamping and of the differences between the individual blades are stated in the manufacturer's instructions.
Cut with light long strokes and without pressure, because the tool works by itself and pressure leads to the blade wandering as well as to the part cracking. Always support the part and hold it as close to the place of the cut as possible, so that the material does not vibrate. First mark the track with a few short strokes, and only then cut at full length. Level the edge after the cut with a file or abrasive paper and degrease the area before gluing. Keep the blades clean, as a deposit of melted plastic in the teeth worsens the cut.
A model, glue, paints and other tools are not part of the delivery, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!