Mineshima Drill Bit 1.8 mm L10-18 is a single modeling drill bit of 1.8 mm diameter for larger holes just under two millimeters. It is held in a pin vise or a micro drill.
Responsibility details are not available.
A single drill bit of 1.8 mm diameter from the modeling range of the Japanese brand Mineshima. It is the last step before two millimeters, and that is exactly why it comes in useful: a hole something is meant to seat tightly in is drilled a tenth smaller, not to the exact nominal size. The L10 series is graded in tenths of a millimeter, so you can afford this difference and do not have to choose between a fit in which the part dances about and a hole it will not go into.
Drill in two steps: a centering hole with a smaller bit, and only then the final size; the larger bit then has nowhere to wander and the edge stays clean. In a thin wall, ease off the pressure near the end, otherwise the bit will bite and tear the edge out. When drilling into a curved surface, flatten a small area with a sanding stick or mark the spot with a point. On parts that are then glued, reckon with a coat of paint narrowing the hole slightly.
For modelers who build military equipment, cars, ships and dioramas and need a reliable fit for axles, tubes and pins. You need a pin vise or a micro drill with a sufficient clamping range to go with the bit.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
