The Mineshima 2.3 mm drill bit is a single modeling bit that suits everywhere a hole for a tubular outlet is to be made, for instance for an exhaust tip.
Responsibility details are not available.
A single drill bit from Mineshima, the Japanese maker of modeling tools. The diameter of 2.3 millimeters is given in the designation of the item, so you can plan the hole according to the actual size of the tube or wire that is to go into it.
A cast exhaust tip in a kit tends to be solid, with a deep mold mark barely hinting at the opening. A drilled hole transforms this detail: the end of the exhaust suddenly looks hollow and the model reads properly even in a photograph. The same procedure works on intake throats, smoke outlets, stacks and everywhere a hole should be there instead of a blanked-off surface.
The drill bit is a tool with a sharp point. Store it out of the reach of children and protect your eyes while drilling.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
