The Mineshima 2.7 mm drill bit is a single modeling bit for work with a pin chuck, where the modeler has both the speed and the pressure fully under control.
Responsibility details are not available.
A single drill bit from Mineshima, the Japanese maker of modeling tools. The diameter of 2.7 millimeters is given in the designation of the item, so you know exactly what you are getting and can fit it into a range of diameters of your own.
A pin chuck looks like a step backwards, but on a modeling bench it has an advantage over a powered drill: you feel when the bit has bitten, when it is passing through a wall and when it is starting to bind. There is no risk of it wandering as it starts up, nor of the plastic melting from high speed. The pin chuck is held between thumb and forefinger, the head rests against the palm and the wrist guides the turning. Drilling is slower, but the result tends to be cleaner than with a small motor guided without support.
The drill bit is a tool with a sharp point. Store it out of the reach of children and protect your eyes while drilling.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!