1:35 Luftwaffe rudder pedals (2 sets)

Luftwaffe rudder pedals 1:35, 2 sets (3DF)

The scale of this set is 1:35. It is not an airplane kit but a 3D-printed detail accessory from 3DF for the cockpit of a model. As the manufacturer states, the package contains two sets of pedals, that is, enough for two models, or you keep a spare in case a small part breaks.

Why aircraft pedals in 1:35 scale

Yes, you are reading that correctly, and it is worth keeping an eye on. 1:35 is traditionally the scale of ground vehicles and figures, whereas aircraft are normally built in 1:32, 1:48 or 1:72. In recent years, though, injection-molded aircraft kits have appeared in 1:35 itself, for example the Bf 109 G-6 from Border Model, precisely so that an aircraft can stand in one diorama with tanks, vehicles and figures in 1:35. In such kits and in cockpit dioramas in this scale, aircraft accessories in 1:35 make sense. Check the scale of your kit before you order, because if you are building an ordinary aircraft kit in 1:32 you need a different variant.

Do not get the scale wrong

The same pedals are made in two scales, 1:32 and 1:35. They are two different products and are not interchangeable. This variant is 1:35, and in a model in 1:32 scale these pedals would be noticeably small, which would show in the cockpit.

What rudder pedals are and why people buy them

The pedals lie on the cockpit floor and on a model with an open canopy they are visible. An injection-molded kit renders them only as coarse suggested blocks, or leaves them out altogether. 3D printing manages an openwork, thin and crisp shape with modeled treadles and straps, a geometry an injection mold simply cannot produce. The designation Luftwaffe means German aircraft: the shape of the pedals differs between air forces, which is why the sets are tied to a particular side. The manufacturer gives neither a particular aircraft type nor a target kit in the name, so compare the shape of the pedals with a photograph of the cockpit of the machine you are building.

Working with 3D prints

• Cut the parts carefully off the supports, as thin openwork pedals break easily.
• Do not use cement for polystyrene, as it has no effect on this material; use cyanoacrylate glue or epoxy.
• Before painting, wash them in lukewarm soapy water so that no print resin is left on the surface.
• Sand exclusively wet; dust from 3D prints is harmful to health and does not belong in your lungs.

The accessory is supplied unpainted and without the base kit. Glue and paints are not included in the package.