1:48 F-16I Sufa - cockpit (Basic edition, 3D decals included) is a printed replacement for the cockpit of the Israeli two-seat fighter, 3D decals included.
Responsibility details are not available.
A set produced by 3D printing that replaces the cockpit of the model of the Israeli two-seat F-16I fighter in 1:48 scale. The basic version contains the main parts of the pilot's station and, with them, 3D decals, that is, decals with a layered relief that transfer the displays and control panels onto the surface complete with an impression of depth. That does away with brush-painting the tiny instruments. The set is not an aircraft model.
The F-16I is the Israeli two-seat variant derived from the late blocks of the F-16D fighter. It is told from ordinary aircraft at first glance: it carries conformal fuel tanks along the sides of the spine and a bulky dorsal fairing housing additional electronic equipment. The rear seat is a full operator's station, not merely a training one, because the aircraft is intended for long-range strikes. The cockpit therefore differs markedly from the single-seat versions.
The printed parts are held on thin print supports. Snip them off close to the part and level the surface with a file or a scalpel. They are bonded with super glue. Apply a primer before painting. Apply the 3D decals only onto a finished and dried clear coat. Use a decal softener on them carefully and in small amounts, because the relief layer is more sensitive than an ordinary decal.
This is an accessory, not a complete model. It is supplied unassembled and unpainted.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
