1:72 BAE Harrier Gr.3 (Late) - Interior 3D-Decals (for Italeri Kits)

Kelik 1:72 BAE Harrier Gr.3 (Late) interior 3D decals

A set of colored, pre-printed 3D decals for rendering the inside of the cockpit in 1:72 scale from the accessory maker Kelik. This is not a kit but decal film with a relief, layered print that reproduces the instrument panel, the side consoles and the controls. The fit matches the later (Late) form, and the color print saves time when detailing a small interior.

The real subject

The Harrier GR.3 was a British V/STOL ground-attack aircraft of the Royal Air Force, intended for close air support and reconnaissance. Compared with the earlier versions it had a lengthened nose with a laser target marker sensor. It operated from forward sites close to the front and from improvised areas.

Use

• Cut the film out, dip it in lukewarm water for 30 to 60 seconds and slide it onto the surface.
• Apply it to a smoothly painted and preferably gloss surface, and gently squeeze out the surplus water.
• Press the part gently down into the relief with a soft cotton swab and, once dry, go over it with matte clear coat. Check the manufacturer's instructions for whether a decal softener may be used with it.

Who the set is for

• Modelers who want a clean, detailed cockpit even in the small 1:72 scale.
• Builders of British jet aircraft.
• Anyone who would rather avoid painting tiny instruments.

The accessory does not include the model itself, nor paints or glue. It serves to detail the pilot's compartment.