GT-108B Mr.Modelling Saw 0,1mm - Blade for Resin Parts (for Mr.Hobby GT-108)

A spare blade for the Mr.Hobby modeling saw, 0.1 mm — for resin

An ultra-thin spare, replacement blade 0.1 mm thick for the Mr. Modeling Saw hand saw from the maker Gunze (Mr.Hobby). It is not a saw but the blade alone for a handle — without the saw you will not use it. This blade is meant specially for resin: resin is hard and brittle, nippers often chip it or crack it, whereas a thin saw separates a part without the risk of cracking.

The blade is extremely thin (0.1 mm) — thinner than ordinary saws — so it cuts a part off with minimal loss of material and leaves a clean, narrow cut. On plastic parts use the corresponding blade meant for plastic; each material needs a differently tuned blade and the wrong choice wears both the part and the blade.

Use

• Separating resin parts from casting blocks without chipping and cracking.
• Accurate dividing of fine resin parts with minimal loss of material.
• A clean narrow cut for the gluing and clean-up that follow.
• Cutting grooves and scribing lines where the thinnest possible cut is needed.

Who it is for

For modelers who build from resin (resin kits and accessories) and own the Mr. Modeling Saw hand saw. For plastic kits choose the variant of the blade meant for plastic.

The blade is very thin and sharp — handle it carefully, as there is a risk of breaking it and of cuts. This is a spare part; the saw itself (the handle) is not included in the package.