R-27ER guided missile, 1:48 is a 3D-printed resin replica of the radar-guided R-27 missile with extended range in 1:48 scale.
Responsibility details are not available.
The set holds a 3D-printed resin replica of the R-27ER air-to-air guided missile in 1:48 scale. It is not an aircraft model but an accessory for the external stores. The extended-range version is noticeably longer and bulkier than the basic R-27R, and that shows on a model straight away.
The R-27ER is the version of the Soviet R-27 air-to-air missile with a more powerful motor and a larger fuel load, which lets it reach considerably farther than the basic version. It is guided by semi-active radar homing, so the on-board radar has to illuminate the target right up to the hit. The longer and thicker body is the unmistakable mark that sets it apart from the basic version. It is carried by fighters of the Su-27 and MiG-29 families.
Wash the 3D-printed parts in warm soapy water first, to get rid of any print resin residue. Cut the print supports off with a sharp blade or a fine saw as close to the part as you can and sand the marks away with respiratory protection. Resin does not bond with polystyrene cement, so use cyanoacrylate glue. Apply a thin coat of primer before painting, otherwise the paint will not hold well on the smooth print. Assemble and paint the armament separately and glue it to the pylon only once the varnish has dried, so that the fine surfaces do not get rubbed.
The set is supplied unassembled and unpainted. Glue, paints and accessories are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
