Landing gear legs for the MiG-29 in 1:48 scale are a 3D-printed resin accessory from Temp Models, reinforced with steel pins.
Responsibility details are not available.
A resin set of landing gear legs for a model of the MiG-29 fighter in 1:48 scale from the Russian brand Temp Models. For the sets in this series the manufacturer states printing from a strong polymer reinforced with steel pins, and the extended position with the lines, the landing lights and a fender picked out. Plastic legs sag in time under the weight of a finished model; here that problem falls away. It is not an aircraft kit but replacement parts.
The MiG-29 has a nose leg with two wheels set well back under the air intakes and protected by a guard against thrown stones, because operation from less prepared surfaces was reckoned with. The main legs retract into the fuselage. On a parked machine the landing gear legs are full of hydraulics, struts and wiring and a viewer looks them over from every side.
Release the parts from the supports with a scalpel and level the mating faces. Wash the resin in lukewarm soapy water before painting. Spray the legs before you fit them and then bring the lines out with a dark tone run into the recesses. A faint oil weep around the shock strut and dust on the lower parts will lend a leg credibility.
The set is supplied unassembled and unpainted. The model, glue and paints are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
