A set of ten files for modeling work. With them you level mating surfaces, take down surplus material and fine-tune the shape of a part where abrasive paper is too soft.
Responsibility details are not available.
A file is the tool for taking off material finely when building a model. With it you level mating surfaces so that the parts fit without a gap, take down surplus material and the marks left by manufacture, and fine-tune the shape of a part where abrasive paper is too soft. Against sandpaper, a file keeps a flat plane, so it does not round off an edge that is meant to stay sharp.
The set holds ten files. Choose the profile according to the spot you are working on: a flat one suits flat surfaces and edges, a round or half-round one goes into holes and curves, and a three-square one into inside corners. The smaller profiles come into their own where a larger tool cannot reach.
Work with a stroke in one direction and with light pressure; force will not speed the work up, it will only clog the teeth. Hold the part so that a thin wall does not flex. A file is not for cutting material apart; use a saw or a knife for that. After filing, dust the surface off and degrease it before painting, otherwise dust will stay in the fine grooves and the finish will later lift off it.
The set of tools is supplied on its own. The kit, paints and glue are not part of the delivery, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
