A modeling aid from the range of tools for building, given under the designation Model Slope Maker. The exact purpose and the working procedure are described in the manufacturer's instructions.
Responsibility details are not available.
This is an aid from the range of modeling tools meant for building, given under the English designation Model Slope Maker. The extent of its use and the procedure for working with it are described in the manufacturer's instructions, so go through them after unpacking before you use the aid on a model in hand for the first time. With tools this holds doubly: most mistakes are caused not by a bad tool but by a tool used for something other than what it was made for.
The proven procedure is always the same. First try the work on an offcut or on a part you will not use again, and only then put a hand on the model. Work on a firm flat surface and in good light, so that it is visible where the tool really seats. Do not press hard; if the work does not go, the mistake is usually in the procedure or in wear, not in a lack of force. Remove the waste as you go, small remnants of plastic under the tool can scratch a surface you have only just finished.
After work wipe the tool dry and free it of dust and remnants of material. Store it so that the working surfaces do not rub against other tools, ideally separately or in a compartment. Do not leave it lying in solvents or in damp. A tool cared for this way lasts for years and works the same all the time.
For modelers who are putting together their own workshop equipment gradually and want more than just a knife and a file at hand. Paints, glue and a kit are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!