The Model Support (Fork Joint) is a modeling holder that holds a part in progress and leaves both hands free for work.
Responsibility details are not available.
An aid from the group of stands that serves to keep a part in progress or a whole fuselage firmly in place so that the modeler does not have to touch it with his fingers. The form of the joint is given in the name of the item, so it is easy to tell apart from the other versions of the same range.
A fork holder allows the clamped part to be tilted into a position in which a joint, an engraved line or the surface being sprayed is comfortably visible. By turning it you reach even places you would otherwise have to turn the whole model in your hand for. The risk of imprints on a fresh coat and of breaking off fine projections falls away with that.
Before clamping, look at whether the supports touch a sufficiently rigid place on the part; thin edges and fine relief had better be padded. When spraying, set the stand so that the stream of paint points away from you, and leave free space around it for turning. Wipe remnants of paint away before they dry on the metal and plastic surfaces.
It pays to think out in advance in what position the model will dry. If a drop stays hanging on the lower edge, once dried it becomes a run that is removed with more difficulty than the whole rest of the coat. It is enough to turn the piece a little further after spraying and let the excess flow into a place that another part will cover anyway.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!