The Model Support (Lumbar Clamp) is a variant of the modeling stand in which a piece in progress is held by a clamp.
Responsibility details are not available.
This item belongs to the group of working aids that hold a model during painting, filling or fitting small accessories. It has the type of holder in its name, and it is exactly by that that it differs from the sister versions of the same range.
A grip from both sides holds a piece stably even when you press on it with a file or rub pigment into it. The model does not rock, so a sanded transition comes out evenly and a graver does not slip off the line. With larger units this is a noticeable difference against holding it in the fingers, where the position changes with every movement of the hand.
Grip the piece only with enough force that it does not move; overtightening strains thin walls needlessly. Under the seating surfaces it pays to put a piece of soft foam or a paper towel. Work over a mat, so that you have somewhere to put offcuts, and clean dust off the stand when you finish, so that the moving parts do not get clogged.
More experienced builders change the position several times during a single stage. There is no sense in struggling with an uncomfortable angle just because reclamping takes a moment; a place that is badly visible is almost always noticed on the finished model, when it is already hard to repair. A short break for resetting therefore saves work in the end.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!