The Model Support (Plug-Style) is a holder in which the model is fitted onto a post and stays freely accessible from every side.
Responsibility details are not available.
A version of the holder that you recognize by the data in the bracket of the name builds on fitting a piece onto a projection instead of gripping it from outside. The model thus stays untouched around its perimeter and the hand reaches it from practically anywhere.
A push-fit joint proves itself where a part has a cavity, an opening left by a landing gear leg or a space in a wheel well. A piece on a post is held by its own weight and light friction, so it can be taken off and put back at any time without loosening screws. It is above all the person who sprays in several passes and sets the model aside to dry between them who will value that.
Try the fit dry before painting and check that the post does not rub against the edges of the opening. If the play is too large, it helps to wind a strip of masking tape around the joint. Put the holder on a flat surface away from the edge of the table, so that a taller model does not fall over when a sleeve catches it.
With painted pieces watch where the post passes through. A fresh coat is soft for several hours after application and the opening easily widens in it, so the joint stops holding. It is sensible to wait with handling until the next day, or at least until the surface leaves no mark when touched.
Wipe remnants of dust off the post from time to time. Settled sanding dust increases the friction and rubs the paint off at a place almost everyone notices in the final judging of a model.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!