Padded Drill Holder from Squadron is a pin vise with a padded handle for drilling small holes in modeling work.
Responsibility details are not available.
This is a modeling tool, not a kit and not an accessory for a model. A pin vise serves to clamp small drill bits and to drill holes by hand, that is, without a motor. The padded handle cushions the pressure into the palm, which tells especially when a larger number of holes follow one after another. Check the exact clamping range, and whether the package holds drill bits, against the manufacturer's data on the packaging.
A powered drill often turns against you in fine modeling work: plastic heats up from the fast rotation, melts, and the hole closes up or frays. Drilling by hand gives you full control over both pressure and direction, the bit does not skip and the surface around it stays clean. Work slowly, start with a light dimple from the point of a knife so that the bit does not run off to the side, and do not push the tool sideways while drilling — thin bits break from being levered, not from pressure. Enlarge a hole gradually through several diameters instead of using one large bit.
It suits anyone who details models: builders of aircraft, vehicles and ships, work with resin and photo-etched parts, and equally a beginner buying a first set of good tools who will appreciate a comfortable handle.
The tool holds sharp drill bits. Work with eye protection, put broken bit ends away from the working surface and keep the tool out of the reach of children.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
