A thin flat strip of 0.75 x 4.0 mm. Planking, a deck plank, an edging strip and flat bar stock in one.
Responsibility details are not available.
A ratio of sides of almost one to five makes flat bar stock out of this profile. It is used as the planking of sides, a plank of a deck floor, an edging strip around an opening or a band of riveted sheet across a wall. The thin material can even be bent slightly, so it follows a gentle curve. The material is white polystyrene, the stick is 35 cm long and it is sold individually.
A worn coat is not a random stain. It arises in the places a boot walks, where a hand rests, where a load rubs or where an edge knocks into another edge. That is why on a flat strip the wear concentrates along the long edges and around openings, not in the middle of an untouched surface.
The most faithful result comes from working with a sponge: a piece of foam is dipped lightly into a dark tone, wiped dry and then only stippled with. Small irregular dots of various sizes arise, exactly like real chipping. Drawing with a brush, by contrast, comes out as a chain of identical dots and gives itself away at first glance.
The strip is parted with a knife in a single stroke along a ruler and glued butt to butt, because its thin edge is almost lost in the surface of an assembly.
Getting a spare makes sense with this shape. When planking, it is used up faster than anything else, and a join between two parts in the middle of a surface shows even after filling and sanding back.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
