The 1.5 x 3.2 mm profile from Evergreen is a white polystyrene strip 35 centimeters long, suitable for heavier battens, square sections and beams.
Responsibility details are not available.
A white opaque polystyrene strip with a section of one and a half by three point two millimeters and a length of 35 centimeters. The section is strong enough that the profile holds its shape on its own and takes a load, so frames and load-bearing elements can be built from it. The material matches the plastic of kits, it is glued with ordinary cement for plastic and it sands well.
A heavier profile is better cut through with a saw than with a knife, and the cut is then squared up with a sanding stick so that the joint sits flush. When building a frame, draw the outline on a base and glue the elements straight onto it. If the profile is to look like a wooden beam, run the tip of a scriber or a wire brush along its length and knock the edges back a little; after painting the plastic then looks like planed wood.
When a longer beam made up of several pieces is to be built from the profile, put the joint where it will later be covered by a crosspiece or a bracket. Nobody will find it on the finished model then.
When cutting, work with a sharp knife or a saw on a cutting mat and do not breathe in the sanding dust.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
