Stripes of yellow paper 5mm

The widest strips of the range on offer: five millimeters of yellow masking paper with a self-adhesive layer.

Manufacturer SX-Art
Product EAN8591111764223

Responsibility details are not available.

4.76 €
3.93 € without VAT
In stock
Free shipping on orders over 1,000 czk in czech republic Personal pickup in Prostějov 14-day returns

About product

Five millimeters, the end of the range

A five-millimeter band closes the range on offer at the top. In 1:48 scale it works out at twenty-four centimeters of real width, in 1:35 scale at seventeen and a half: that is, roughly the dimension of a wide recognition stripe or of a band of fuselage that on large machines was set apart as a whole. It is also used as a quick way of defining a boundary on two-color camouflage with a hard division, where the dividing line is to be absolutely straight.

A straight line the eye can tell

A hard division is merciless. The slightest waviness of an edge is visible on a finished model, because the eye reads a straight line more easily than any other shape. With wide bands, therefore, it pays to establish two reference points at the ends first, stretch the strip loosely above the surface between them and only lower it once you have checked. Anyone who lays a band gradually from one end usually ends up with a curve that they learn about only after spraying.

Before you start spraying

The varnish under the mask should be cured, not merely dry to the touch; with solvent-based paints the difference between one day and a few hours matters a great deal. Spray perpendicular to the edge, and rather in two passes than in one heavy coat. The remaining area can be covered with anything that holds: paper, film or cardboard; the accuracy is taken care of by the edge of the strip alone.

A few words about the material

Compared with film, a paper carrier has one practical advantage: it can be torn across with the fingers and the edge stays acceptably straight. When you need a piece quickly and have no knife at hand, it is enough to fold the strip and tear it over a fingernail. That will not do for long runs; for short ones it will.

Reviews

No reviews yet Have you built this one? Tell other modellers how it went and help them choose.

Forum

Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.

Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.

There are no questions here yet. Be the first to ask!

FAQ

In 1:48 scale twenty-four centimeters, in 1:35 scale seventeen and a half. That corresponds to the width of a wide recognition stripe.

Set yourself two points at the ends, stretch the strip loosely above the surface between them and lower it only after checking. Laying it gradually from one edge leads to a curve.

Until it has cured, not merely until it is dry to the touch. With solvent-based paints the difference between a few hours and a whole day is fundamental.

Last seen

SX-ArtSXA20071

Stripes of yellow paper 5mm

The widest strips of the range on offer: five millimeters of yellow masking paper with a self-adhesive layer.
In stock
4.76 €
UMUMMT7031:72

1:72 Tank RBT-7 With Rocket Launcher For RS-132

1:72 Tank RBT-7 With Rocket Launcher For RS-132 is a plastic kit of the Soviet fast tank of the BT series completed with a launcher for RS-132 rockets, in 1:72 scale from the maker UM.
In stock
13.96 €
Artwox ModelAW200731:700

1:700 USS Baltimore CA-68 1944(For Trumpeter 05725)

The Artwox Model 1:700 wooden deck for the heavy cruiser USS Baltimore CA-68 in her 1944 state is an accessory to a plastic kit. A self-adhesive veneer will replace the engraved plastic deck of the Trumpeter 05725 kit.
In stock
13.16 €
QuickwheelQW-1611:35

1:35 2S3 152mm Akatsiya - Trumpeter

The Quickwheel 1:35 2S3 152 mm self-adhesive masking set for the road wheels of the Soviet self-propelled howitzer is cut for the kit from Trumpeter. It separates the rubber tire band from the rim.
In stock
7.56 €
BrengunBRL721171:72

1:72 Zlin Z-50 CANOPY MASKS (Brengun kit)

A 1:72 masking set for the cockpit canopy of the Zlin Z-50 aerobatic aircraft is an accessory to a kit you have already bought, not a model. The self-adhesive masks prepare the glazing for spraying the frames.
In stock
4.76 €
Loading, please wait...

Setting consent to personalization

With your consent, we may use the information below for the following purposes or share it with selected partners. You can adjust your settings for individual purposes (types of processing) and confirm your choice with the "Save settings" button:

Always active

Necessary cookies

These are technical files that are necessary for the correct behavior of our website and all its functions. They are used, among other things, to store products in the shopping cart, display products on request, control filters, personal settings and also set consent to the use of cookies. Your consent is not required for these cookies and it is not possible to remove it.

Analytical cookies

They count website traffic and, by collecting anonymous statistics, enable the operator to better understand their visitors and thus constantly improve the site.

Marketing cookies

They collect information to better tailor advertising to your interests, both on and off this website.

Setting consent to personalization

To make it easier for you to browse the site, to offer you customized content or advertising, and to analyze traffic anonymously, we use cookies that we share with our partners for social media, advertising, and analytics. You can adjust their settings with the "Edit settings" link and you can change it at any time in the footer of the website. You can find more detailed information in our Policy on the protection of personal data and the use of cookies.