Ten flat strips of ABS of 0.25 x 4.00 millimeters in section and 350 millimeters long, 3.5 meters of material in all for building parts of your own.
Responsibility details are not available.
The bag holds ten flat strips of ABS. Each has a section of 0.25 x 4.00 millimeters and a length of 350 millimeters, so in all you get 3.5 meters of material. It is stock for building parts of your own, not a finished part nor a set for a particular kit.
A quarter of a millimeter really is very little, and that is exactly the strength of this size: the strip behaves like thin sheet metal. It suits cladding, imitating metal bands and covers, covering gaps, thin strips and repairing a broken-off detail. Because it is pliable, it can be laid even onto a curved surface and held until the glue takes, without lifting away from the base. A width of four millimeters corresponds in 1:35 scale to roughly fourteen centimeters in reality and the thickness to just under a centimeter, which is the size of an ordinary cladding strip.
A thin strip is usually cut through with a sharp blade against a metal ruler in one or two strokes; draw the cut slowly, so that the material does not slip under the blade. Then sand the end level with fine sandpaper. Use cyanoacrylate glue or a glue meant for ABS. If you want to join it with a solvent cement for polystyrene, try the joint on an offcut first, because ABS reacts to it differently from ordinary modeling plastic. Before painting, wash the surface, degrease it and apply a primer.
Glue, paints and tools are not part of the delivery, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!