The DSPIAE 1.7 mm tungsten steel drill bit is a single bit for plastic models. An in-between size you will not find in ordinary sets, but one that decides whether a part seats tightly.
Responsibility details are not available.
DSPIAE has modeling drill bits in single diameters in steps of a tenth of a millimeter. This item is the 1.7 mm diameter. The name gives both the material and the size; it is a tool, not a model part.
General-purpose sets usually step in half millimeters, so between 1.5 and 2.0 mm you have nothing. Yet that is exactly where most of the trouble arises. When you seat a brass tube, a wire or a pin in a hole, a few hundredths of a millimeter decide the quality of the joint. A hole a touch narrower means you cannot force the part in without risking a crack. A hole half a millimeter wider means a visible gap you then have to fill with glue and afterwards putty and sand back.
The 1.7 mm diameter is therefore practical as a complement to what you already have at home: either as a tight seat for a part two tenths thinner, where you want to leave clearance for glue, or as a hole for a part that is nominally 1.7 mm and would turn loose in a 2.0 mm hole.
For the modeler who has outgrown a general-purpose set and wants to hit a particular size first time. Also for anyone building up their own range of diameters according to what they actually use.
Sharp tip, keep out of the reach of children. Use eye protection while drilling and drill on a firm support.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!