LACI 1:144 Convair 880-22 Landing Flaps is a resin set of the extended high-lift devices of the wing for a model of the American Convair 880 jet airliner. It is an accessory to a plastic kit, not a model of an airplane.
Responsibility details are not available.
A resin set that on a Convair 880 model replaces the smooth trailing edge of the wing with fully extended high-lift devices. It is intended for the basic 880 version designated Model 22 and complements a plastic kit in 1:144 scale. It is not a kit of an airplane but a conversion part for a more advanced build.
The Convair 880 was an American four-engine jet airliner from the end of the 1950s. In design terms it was narrower and lighter than the competition of the day, which gave it the reputation of one of the fastest airliners of its time. Commercially, however, it did not succeed: the smaller capacity and higher operating costs meant that only a small series was built, and the type remained an interesting chapter of the beginnings of jet transport rather than anything more. The basic Model 22 was intended mainly for American domestic routes. For a modeler the 880 is attractive precisely for its rarity - a finished model with the devices extended will meet nothing like it in a display case.
First wash the castings in lukewarm water with detergent, so that the mold release agent disappears from the surface. Cut the casting blocks off with a fine saw and level the mating surfaces by sanding; sand with breathing protection, ideally wet. Part of the kit wing is cut away, so mark the position of the cut, try the part dry and only then work. It is glued with cyanoacrylate glue, because cement for plastic does not work here. Once it has cured, apply a primer and fill the seams if necessary. Aircraft of the early jet era often flew with unpainted metal surfaces, so it pays to polish the surface carefully before applying a metal shade; mix the metallic paint thoroughly and leave it until the end, because it is hard to mask.
This is an accessory set, not a stand-alone model. The base kit, glue and paints are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!