An add-on set for a model of the Boeing 717 in 1:144 scale that puts the aircraft into landing configuration with the wing high-lift devices extended.
Responsibility details are not available.
The Boeing 717 is a short twin-engine airliner for regional and short routes, the last member of the family derived from the Douglas DC-9. It is easy to recognize: the engines sit on the sides of the rear fuselage and the tail surfaces are arranged in a T. In 1:144 scale it is a small model, on which every protruding part on the wing changes the overall impression markedly.
The set puts the model into landing configuration, that is, into the form in which the aircraft has the wing high-lift devices extended. The exact extent of the parts and which sections of the wing are replaced on the model is given in the manufacturer's instructions; how much material has to be removed from the original part follows from them as well.
The parts are not polystyrene, so ordinary cement for plastic models has no effect on them and the joints are made with super glue. Cut the surplus material off with a sharp blade a little away from the part and carefully sand the remainder down. Wash and degrease all the parts before painting, otherwise the finish will not take. Always dry-fit the parts first and only then glue them, because every deviation shows on a wing in this scale.
The set is intended for modelers of airliners who want to build the model in the attitude of an approach to landing rather than in the clean cruise configuration. It assumes experience with add-on parts and with modifying a kit. The aircraft model, the paints and the glue are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
