Resin wheels for the GAZ-AA in 1:35 scale from PANZER ART in the variant with tires from the Omsk plant. They replace the plastic castings from the kit with a clean part that has no mold parting line.
Responsibility details are not available.
A set of resin road wheels for the Soviet GAZ-AA truck in 1:35 scale. It is not a model of the vehicle but an accessory for a kit already built or part-built: the plastic wheels are cut off and replaced by more accurate castings. This is the variant with tires from the Omsk plant, and the manufacturer makes a version with tires from the Yaroslavl plant alongside it.
The GAZ-AA was the basic Soviet truck with a one-and-a-half-ton load capacity, produced under American license, which in the 1930s and 1940s became one of the most widespread vehicles in the country. It carried supplies, served as a workshop and special-purpose chassis and accompanied units in practically every operation of its time. Tires for it were supplied by more than one plant and their form differed from one another, so the choice of the right variant of wheels shows at first sight on a model.
Wash the castings in lukewarm water with detergent, so that they are rid of the mold release agent, or the paint will not hold. Cut the casting blocks off and level the mating surface; use protection for your airways while sanding resin. Glue the wheels with cyanoacrylate, since cement for plastic does not work here. Once the primer has been sprayed, bring the tread pattern out with a very dry brush and add dust or mud pigments, as the wheels are the first place on a vehicle a viewer notices.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!