A full photo-etched set for the main landing gear bays of an A-20G Havoc model in 1:32 scale from the Czech manufacturer Eduard. It is not an aircraft kit but an accessory for a model you have already bought.
Responsibility details are not available.
A photo-etched set from Eduard aimed at the main landing gear bays of a model of the A-20G Havoc attack aircraft in the large 1:32 scale. It is a full photo-etched set, not a smaller selective version from the Zoom range. It is not an aircraft model; the parts are fitted to a kit you have already bought. Check the exact extent of the set against the instructions enclosed with it.
The Douglas A-20 Havoc was a twin-engined attack and light bomber aircraft with tricycle landing gear, on which the main gear retracted into the engine nacelles. The A-20G version has a solid, unglazed nose with fixed gun armament. On an aircraft with tricycle landing gear the gear bays are visible from below and from the side on a displayed model, and the plastic parts from the box usually have no structure in them at all.
Finish and paint the bays before you close the nacelles up; later you will no longer reach them. Separate the photo-etched parts with a sharp knife on a hard surface, bend them in a bender or over a steel rule and glue them with cyanoacrylate, or with two-part epoxy, which gives time to line them up. Cut away the plastic detail the photo-etch replaces and sand the surface back. Treat the metal with a filler primer before painting. The structure of the ribs and the runs in the bays will stand out if you accentuate it after painting with a dark wash and a dry brush.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
