Double-sided masks for the glazing of the 1:32 Sea Hurricane Mk.IIc, allowing the cockpit frames to be sprayed from the inside as well as the outside.
Responsibility details are not available.
The naval Hurricane was never a dream carrier fighter. It came about out of necessity, because the Royal Navy needed something faster than a biplane at once and the new types were only getting under way. Even so it did its job: it protected convoys, drove off long-range reconnaissance aircraft and its pilots learned to land on decks that were uncomfortably short for a land machine. From 1943 it was gradually pushed out by American fighters and by the British Seafire, so that by the end of the war only examples with training units were left.
At a large scale every simplification gives itself away, and most of all on the cockpit. If the frames are sprayed only from the outside, bare plastic shows through the clear part and the illusion of a glazed space falls apart. This variant of the masks therefore holds shapes for the outer and the inner side, so the framing gets the interior shade and the camouflage color on the outside.
First the inner side is covered and the interior shade sprayed; once dry, the part is turned over and masked from the outside. Flat panes tempt you into laying a template on slightly crooked, so check the position against the light before you start thinning the paint. It pays to let the varnish cure properly between the two rounds, otherwise the inner layer will slip when the second mask is applied. The inner masks stay in place until the end of the build, because they protect the glass from overspray and from fingerprints.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!