RIVETER TRIPLE 1.00 MM is a triple-row riveting wheel for imitating rows of rivets on plastic models. The figure 1.00 mm in the name identifies the size of the variant within the range.
Responsibility details are not available.
A triple-row riveting wheel for imitating rows of rivets in plastic. It is not a kit and not an accessory to one particular model but a workshop tool that will last for dozens of builds. The designation TRIPLE corresponds to the triple-row version — the brand distinguishes the single-row and double-row variants in the same way. The figure 1.00 mm in the name distinguishes the individual sizes in the range: a lower value means a finer impression, a higher one a coarser impression. This variant belongs to the coarser part of the range.
The coarser end of the range is aimed at larger scales and at hardware where the joints are massive and the rivets pronounced — hulls, armor plates, girders, ship hulls. On large areas a clear impression is desirable, because the model is viewed from a greater distance and fine dimples would be lost. The triple-row version covers a wide seam in one pass instead of several repeated ones.
On large areas work in shorter sections and wipe the wheel between them. Accumulated plastic dust lifts the wheel off the material and the row then weakens toward the end of the pass.
Care: keep the working part clean and dry and store the tool so that it does not get knocked about against other tools. The package contains the riveting wheel itself; plastic, templates and paints are not included.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
