A decal sheet with the license plates of American military vehicles of the Second World War in 1:35 scale.
Responsibility details are not available.
American military vehicles of the Second World War did not drive around anonymously. Every machine had its registration markings, and to those were added unit and tactical markings by which it could be told whom the vehicle belonged to and where it was heading. It is precisely these small plates and numbers that give a model a story: without them even a nicely built vehicle looks like an exhibition piece from the factory, with them like a machine assigned to a particular unit.
License plates for American vehicles from the Second World War in 1:35 scale, that is in the most widespread size for ground equipment. You will use them on jeeps, trucks and staff cars alike, whether you are building a single model or a whole convoy for a diorama.
A decal holds best on a smooth glossy base, so coat the place with gloss varnish and let it cure. Cut the item out together with a margin of the carrier film, soak it in lukewarm water and let it rest for a while until it loosens. Move it onto the model and press the water and the air out from under it with a soft brush or a cotton swab. For small irregularities a decal softener helps. Finally even the area out with matte varnish, so that the glossy island around the plate disappears. To be sure, compare the procedure for this sheet with the manufacturer's instructions.
For builders of Allied equipment in 1:35 scale who want to add particular markings to their vehicles. The model, paints and varnishes are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!