A double-sided painting mask for a model of the KAMAZ-65115 dump truck in 1:43 scale. It covers the glazing outside and inside, so the window frames stay sharp after spraying.
Responsibility details are not available.
The subject is the three-axle KAMAZ-65115 dump truck with 6x4 drive, that is a typical representative of the construction equipment that has been appearing in quarries and on building sites all over Eastern Europe since the end of the 1990s. The vehicle derives from the proven family of trucks from Naberezhnye Chelny, and the payload of its bed is around fifteen tons.
On a model of a commercial vehicle the windshield is large and its frame forms a prominent visual line. One-sided covering does protect the outer surface, but from inside the trace of the spray shows through the glass, and when you look into the cab it comes across as unfinished. The set deals with both, because it contains shapes for the outer as well as the inner side of the glazing.
Before sticking it down, the glazing has to be rid of grease from the fingers, or the edge will not seat and the varnish will bleed. Lead the spray perpendicular to the surface and rather in several weak coats. Remove the mask while the paint has only set, not after it has fully cured, when the edge may tear.
Compared with cars, trucks have a peculiarity that is often forgotten at this reduction: the rear wall of the cab tends to be glazed too, and on some renditions there is a roof hatch. If those surfaces are left fogged after spraying, the cab loses its see-through and the whole vehicle comes across as ponderous.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!