20% OFF Sale Until Wednesday!
MASTER • KELIK • RESKIT • QUINTA STUDIO • EDUARD • GUNZE • VALLEJO • HGW • DEAD DESIGN • FIRMA49 • KOVOZÁVODY PROSTĚJOV • AZ MODEL • RS MODELS
Sale Ends Wednesday, November 11, 2026!
A resin fuel pump cover for the IA 58 Pucará in 1:48 scale is a detail accessory from Quickboost. It is not a model of an aircraft but a replacement part for a kit.
Responsibility details are not available.
A small detail part cast in resin for models of the IA 58 Pucará in 1:48 scale from Quickboost, which belongs to the family of the Czech manufacturer Aires. It is not a kit or a model of an aircraft; it is a single replacement part with which the fuel pump cover on a model is replaced or completed. The exact number of parts and the contents of the package are stated on the box.
The philosophy of this range of accessories is simple: replace one particular simplified part without having to interfere with the whole build. Small covers and drain fittings in a kit tend to be either suggested only by engraving or cast as a blunt lump with no detail; a resin casting has crisp edges, legible panel lines and the correct profile. The swap takes a few minutes and shows up exactly in the place that is visible on a finished model. The set calls for no experience with larger resin conversions.
The IA 58 Pucará is an Argentine twin-engine turboprop aircraft intended for reconnaissance and close support from short and unpaved strips. It is characterized by its tall, markedly tapered fuselage, a two-seat cockpit in tandem and fixed armament in the forward part of the fuselage. The design was driven by the requirement to operate from improvised airfields, so it has sturdy landing gear and easily accessible service panels.
Wash the casting in lukewarm soapy water so that the mold release agent disappears. Cut the casting block off with a new scalpel or a razor saw and level the face gently on sandpaper; when sanding resin, work wet and protect your airways. Level the original part or the lump on the fuselage flush, so that the replacement seats properly. It is glued with cyanoacrylate glue applied with a pin. Paint it together with the whole airframe so that the shade matches, and bring out the panel lines with a thinned wash only after a gloss coat.
The accessory is supplied unpainted. Paints, glue and the base kit are not included in the package. We recommend checking that it matches your kit before buying.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
