Eduard 1:48 A6M2 Zero tailwheel (3D printed) is a 3D printed resin set of the tailwheel for models of the A6M2 Zero fighter in 1:48 scale.
Responsibility details are not available.
A small set made by direct 3D printing that holds a faithful tailwheel and a separate cover for a model of the Japanese A6M2 Zero fighter in 1:48 scale. It is not an aircraft model but a detail accessory that replaces the kit part with a finer and more accurate rendering. 3D printing technology allows very sharp detail with no parting seams.
The A6M2 Zero was a carrier fighter of the Imperial Japanese Navy Air Service, famous for its long range and agility. The rear tailwheel is a small but conspicuous feature that easily draws attention on a finished model.
Carefully separate the parts from the print supports and clean them up. Glue with cyanoacrylate glue (super glue). Paint the tire and the hub separately; suggest light wear with a dry brush. Handle the fine parts with care.
The set is an accessory, not a complete model. It is supplied unpainted; glue, paints and the kit are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
