Bare feet in a bent position 1:72 are an accessory for figures with which you replace a shod leg where a figure is meant to be barefoot. It is neither a figure on its own nor a kit.
Responsibility details are not available.
This is a small accessory for figures in 1:72 scale, not a whole figure and not a kit of a model. The set captures bare feet modeled in a bent position, that is with the ankle flexed and the toes curled down. It is used everywhere the original figure offers only a shod variant while the scene calls for a figure without footwear.
Bent feet suit above all figures that are not standing upright. Typically these are seated figures with a leg stretched out in front of them, kneeling figures, the wounded lying on stretchers or civilian scenes by water. It is precisely the angle of the ankle that distinguishes this part from a foot modeled in the basic stance, and in small scales it is the detail that decides whether the resulting figure comes across as natural or stiff.
Cut the original foot off with a sharp scalpel or a fine saw at the place where the new part follows on. Level the cut and the mating surface with a file, try the part dry first and fine-tune the angle, and only then glue. Super glue works well, or else a two-part filler, with which you fill the seam at the same time. Before painting, sand the joint over with fine sandpaper and spray the whole figure with a base coat, so that the shade of the skin has a uniform ground. In 1:72 scale one lighter base layer is enough for skin, with a darker wash flowed into the recesses of the ankle and between the toes and a very fine dry brush on the instep.
The accessory is supplied unpainted. Glue, paints and the figure itself are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
